- PGVG 200
- Тип монтажа
- серо-белый (RAL 9002)
- Европейский номер изделия (EAN)
emergency light supply units for operating 1 or 2 luminaires with
incandescent lamps or low pressure discharge lamps with electronic
Single battery system design in accordance with EN 60598-2-22.
Battery: sealed Pb battery.
Housing: 960 °C glow wire tested
Output: 183W (rated duration 1h) / 78W (rated duration 3h)
Length with fixing bar: 745mm
Electronic unit with charger, 2 power monitoring units, 2
switch units, DC-DC converter / DC-AC converter, 2
lighting circuits, deep discharge protective shutdown and automatic
self monitoring function.
Luminaires can be operated in non-maintained or maintained power mode. Separate
light inputs and outputs, and control inputs to switch the
luminaires in mains operation, per lighting circuit.
Battery is charged through input 1. If mains power
fails on input 1 and/or input 2, charging is
interrupted and output 1 and/or output 2 is fed from the
battery. Once mains power is restored, the device switches
back from battery to mains operation after a short delay (10s). During mains operation,
the luminaires can be switch individually from non-maintained
to maintained power mode using control inputs 1 and 2. An
external switch (passive) or external control signal (active) can be used to remotely
block switchover from mains to battery operation. The
device shuts down automatically if overheating, overload or a short circuit occurs
during battery operation. The standard self monitoring function performs
automatic weekly function tests (charger,
switch unit and lighting circuits) and annual
rated duration tests (battery capacity). The luminaires are
controlled by a self adjusting power management system.
A display and foil key show operating states and
malfunctions and permit function tests to be triggered manually.
A message output can forward group malfunctions to an
external alarm system.
Battery unit with maintenance free sealed Pb battery,
service life: 6-9 years according to EUROBAT.
Battery and electronic units in separate boxes in accordance with EN 50272-2.
Battery unit with ventilation slit.
Screw-fastened lid, hinged at the side. Wires threaded through
Mains supply: 1~/N 230 V; max. 0.25A; 50 Hz
Output voltage: 230 V ~ (mains), 170¸ 225 V = (battery)
Permissible ambient temperature: + 5 to + 45 °C (electronic unit), 0 to
+ 20 °C (battery unit)
Type of protection: IP56 (electronic unit), IP33 (battery unit)